Maintaining the brakes on your Ford Transit Full Size 150/250/350 is crucial to ensure safe and reliable driving. One of the most common maintenance tasks you might encounter is changing the rear brake rotor/disc axle. While it may seem like a daunting task, it can be done easily with the right tools and a little know-how. In this quick video guide, we’ll walk you through the steps to change the rear brake rotor/disc axle on your Ford Transit Full Size 150/250/350.
Step 1: Prepare the Vehicle
Before you begin, make sure the vehicle is parked on a flat and level surface, with the parking brake engaged. Use a lug wrench to loosen the lug nuts on the rear wheels, but do not remove them yet.
Step 2: Raise the Vehicle
Using a floor jack, lift the rear of the vehicle until the wheels are off the ground. Place jack stands under the frame for additional support, and then lower the vehicle onto the jack stands.
Step 3: Remove the Rear Wheels
Remove the lug nuts and take off the rear wheels. Use a wire brush to clean the brake assembly and rotor, and then set the wheels aside.
Step 4: Remove the Caliper and Bracket
Remove the caliper bolts and slide the caliper off the rotor. Hang the caliper with a wire hanger or bungee cord to avoid damaging the brake line. Then, remove the bracket bolts and take off the bracket.
Step 5: Remove the Rotor/Disc Axle
Remove the retaining clips or screws that hold the rotor/disc axle in place. If the rotor/disc axle is stuck, use a rubber mallet to tap it loose. Then, remove the rotor/disc axle from the wheel hub.
Step 6: Install the New Rotor/Disc Axle
Place the new rotor/disc axle onto the wheel hub, and then reinstall the retaining clips or screws. Replace the bracket and caliper, and tighten the bolts to the manufacturer’s specifications. Finally, reinstall the rear wheels and tighten the lug nuts.
Step 7: Test Drive the Vehicle
Lower the vehicle off the jack stands, and then use the floor jack to remove the jack stands. Lower the vehicle to the ground and tighten the lug nuts again. Test drive the vehicle to ensure the brake system is working properly.
Ford transit full size 150/250/350 How to change Rear Brake Rotor/Disc Axle Remove Quick Video
Changing the rear brake rotor/disc axle on your Ford Transit Full Size 150/250/350 is a necessary task to maintain your vehicle’s braking system. By following the steps outlined in this video guide, you can complete the job quickly and easily. Remember to take your time, use the right tools, and follow the manufacturer’s specifications to ensure the job is done correctly.
